MakerWorld
Other Hobby & DIY
Model downloaden
Exhaust Vent Cover
281
Downloads
74
Likes
99
Makes
I made an exhaust vent cover used on a DIY BOFA filter unit used for laser engraving. This cover directs the exhaust air from the filter unit down, based on the direction it is installed. This was made to fin a Dayton 1TDR3 Model Blower Motor, it may fit other similar models.Dayton 1TDR3 Model Blower Motor: https://amzn.to/4a00uPq (As an Amazon Associate I earn from qualifying purchases)
imp22b publiceert ook op
8 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
