Exo 1400 remix

Updated Stephan's work as the angle is not great for filming it is aimed too far down. simple rough adjustment. Thank you stephan for the model, it is a good basis.

Print with PLA, would recommend relatively high infill 40-60%. No support required, mount on the helmet in print angle, use 3M adhesive available at amazon, to adhere to helmet in print orientation.

BTW I am no expert and relatively new to 3D printing just did a rough adjustment using tinkercad.

First picture is old design, second picture is new design and third is new design installed. it is not perfect but it works a lot better as the old design.