Slicer Discord
ExoGuitar - Strap Hooks + Wall Mount – 3D-printbaar model van MakerWorld MakerWorld
Music

ExoGuitar - Strap Hooks + Wall Mount

5 Downloads
5 Likes
2 Makes
Model downloaden
This was designed for the ExoGuitar system, allowing users of the ExoGuitar system to mount their guitars to the wall via the same connection points that connect the Strap to the Guitar. BOM: 2x M3 2020 Sliding Nuts2x M3x25 SHCSSuper GluePainters Tape4x Drywall screws Assembly: Glue the M3x25 Screw into the outer portion of the mount. Insert the M3 2020 sliding nuts into the Aluminum extrusionInsert the bottom of the mount into the strap, and then put the screw through the top of that assembly.Screw the above assembly into the M3 2020 sliding nuts, tightening them where you want the straps to go.Lay a piece of painter's tape actoss both mounts taught, and then mark with a pen where the screws are. Take that piece of tape over to the wall, and position it where you want the body of the guitar to go. Screw the wall mounts to the wall, placing the bottom hole where the mark is on the tape. If you want to sell ExoGuitars, please join this membership: https://patreon.com/SpikeonStudio?u
Categorie
Music
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Lijmen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Spikeon Studio publiceert ook op

38 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie