Exost360 Wheel

This is a wheel for Exost360. It does fit the "axe de roue exost 360" (thing 2422499). by the way you can see how it works inside (added 2 pictures).
THIS IS NOT A REMIX of the axe, but works with it !

I made a first version, weaker, that did not pass the first "kid crash test"... So I added more plastic to maintain the wheel to the sentral axe. See the 3 pictures to get an overview of the internal portion of the wheel

The internal surface of the axe (that is in contact with the wheel axe 2422499) is not perfect due to the low quality, so it "scratch" a bit when itis inserted. I had to push to "click" the wheel to the axe. But at the end, this is fine as it does not move then. :-)

It does take around 2h16mn to print with low quality (no need for more).
Configuration in cura :
> low quality : 0,28mm
> support activated "everywhere"
> support overhang angle at 60° (high enough to get support only in the groove)
> No adhesion