Thingiverse
Expansion Card Holder
von TheOrginalRis
55
Downloads
38
Likes
0
Makes
Expansion Card Holder for Framework Computer Inc. Laptop Expansion Cards.
Holds up to:
6 expansion cards
6-12 SD Cards when combined w/ Expansion Cards (much more without)
3 SMALL USB Drives
Many MicroSD Cards (Haven't counted the actual amount able to fit)
1-3 Microfiber Cloth's
***NOTE: The amount above is based on configuration you choose not all of that will fit at the same time***
This is just a prototype but its at the stage where I wanted it to be for my use case. I decided to post it because I was asked for the file a few times.
Lid uses friction to stay in place so tolerances are very important and you may have to adjust that based on your printer.
Holds up to:
6 expansion cards
6-12 SD Cards when combined w/ Expansion Cards (much more without)
3 SMALL USB Drives
Many MicroSD Cards (Haven't counted the actual amount able to fit)
1-3 Microfiber Cloth's
***NOTE: The amount above is based on configuration you choose not all of that will fit at the same time***
This is just a prototype but its at the stage where I wanted it to be for my use case. I decided to post it because I was asked for the file a few times.
Lid uses friction to stay in place so tolerances are very important and you may have to adjust that based on your printer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
