Thingiverse
Toys & Games
Model downloaden
Extendable Pointing Finger
214
Downloads
999
Likes
1
Makes
Wanted to make one of those extendable pointing fingers going around, but couldn't find a proper one.
So I decided to make it on my own, it extends up to **60 cms** and is quite sturdy when done so.
Simple to assemble, print each part, slide the rods into each other, put the cap on the bottom and the finger and the top, and enjoy!
#### Print Settings
Not much to say here except:
**Zero supports needed**
The rods are best printed **together** as it takes less time due to minimum layer time.
I've tested it with **PLA** but **PETG** should be fine too or even better.
This was printed at **0.2mm** layer height with a **0.4mm nozzle**
So I decided to make it on my own, it extends up to **60 cms** and is quite sturdy when done so.
Simple to assemble, print each part, slide the rods into each other, put the cap on the bottom and the finger and the top, and enjoy!
#### Print Settings
Not much to say here except:
**Zero supports needed**
The rods are best printed **together** as it takes less time due to minimum layer time.
I've tested it with **PLA** but **PETG** should be fine too or even better.
This was printed at **0.2mm** layer height with a **0.4mm nozzle**
RioTheDev publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
