Extended Filament Guide

I love the feeder, but felt it didn't leave enough room between the sensor and entering the extruder. I moved it back about 40mm from the extruder so that the filament can be removed if the sensor is triggered on a runout.

The new mounting bracket is thinner, so you'll need four M3 bolts about half the length of the originals and four M3 nuts to close the sensor case using the stock M3 bolts.

Since I've mounted this I've tested the runout and it's a million times easier to swap filaments.

Let me know if you run into any issues and I can make changes as needed.