Slicer Discord
Extended Golf Handle - Quest 2 – Modello 3D stampabile da Thingiverse Thingiverse

Extended Golf Handle - Quest 2

71 Download
50 Likes
3 Makes
Vai al Modello
For putting / golf games on Quest2

Because this uses the original controller orientation it seems to work fine without needing pre calibration for specific grip models, which is as of today is not supported in the games I use. Gripping lower on handle may have unintended results in some games, otherwise if keeping the main hand near original controller grip position this should work per normal, but with the benefit of having somewhere to grip for your second hand.

Be sure to use the wrist strap looped through the hole and attached to your wrist per usual when playing for a more secure setup. The clip alone (even the tighter T2 version) is insufficient IMO but looping a ponytail band or otherwise through that area (or through the wrist strap again) to the controller halo is an additional connection point if desired (see photo under “makes”). The t2 tightening clip should slightly tighten when pushed; may need to be tapped against a hard surface in opposite direction to remove,
Fonte
Thingiverse
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
PLA
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione