Thingiverse
Extended MakerGear M2 Spool Holder
por Neo_Usagi
88
Descargas
55
Likes
5
Makes
This is a modified version of the stock Makergear M2 spool holder. I really like the stock spool holder because its strong and holds the spool in place well. The only problem is that it is really short. So I made two versions. One that is long enough for narrow spools and one a bit longer for the thick squat spools. I did my best to maintain the overall geometry of the holder so it isn't just a stretched version of the spool holder but one where the center section was lengthened.
They should print fine in either ABS or PLA. No supports needed.
They should print fine in either ABS or PLA. No supports needed.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!