Thingiverse
Extended Threaded Dust Filter Center
door StarNamer
3
Downloads
1
Likes
0
Makes
I found the original [threaded dust filter](https://www.thingiverse.com/thing:497764) fitted perfectly on the filament guide I'd previously attached to my Eder 3, but the extra space for the guide meant that the inner part didn't reach the bottom of the outer.
By extending the thread by 7mm it now screws in without leaving a gap at the bottom.
By extending the thread by 7mm it now screws in without leaving a gap at the bottom.
StarNamer publiceert ook op
8 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
