Extra Thin BIQU H2 Mount (MAD Compatible) - Ender 3

Extra Thin H2 Mount
=========
This model is designed specifically to work with Predy's [“MAD - Modular Air Duct for BIQU H2”](https://www.printables.com/model/146957-mad-modular-air-duct-for-biqu-h2)
------------------

Reclaim lost build volume on your ender 3 with **the thinnest mount out there!** This mount is only **5mm thick** while still being rigid enough to handle relatively fast accelerations without too much wobble.
The removeable fan mount makes the already hard to service H2 just a little bit easier and allows you to have two colours to *match your aesthetic.*

**(There are a few ender 3 backplate variations, check first)**

Print Settings
====================

**The file "H2 MountPlate" makes use of sacrificial bridges to avoid support!**

* 0.15mm Layer Height *(A must for the sacrificial bridges to work!)*
* No Support
* 100% infill for rigidity
* I used PLA as it is quite rigid, however, ASA or nylon may be better choices.

Hardware
=============