Thingiverse
Extreme Bow Stabilizer V2 - Customizable!
by myeh2k
104
Downloads
86
Likes
1
Makes
This bow stabilizer is the 2nd version of this one: https://www.thingiverse.com/thing:2458936
Improvements include:
- Better print-ability without supports.
- Smaller dimensions (less plastic = faster print)
- Improved slots for bolts
I wanted to create a simple bow stabilizer that is not only great looking, but also is functional. This version of the stabilizer will save you a lot of print time, and material. By using 4 used/old/found arrow shafts, and going to the store to buy a couple of parts, this project will cost you only about $5.
3D Parts needed:
- 1x Receiver (1.25" OR 2")
- Rail (Need 1. Print as many as you would like)
- 1x Barrel
- 1x Flash Hider OR Silencer (Optional, but it adds on to the looks of it.)
Parts required to assemble:
- 4x 7.8mm Arrow shafts
- 1x UNF 5/16*24 1.25" OR 5/16-24 2" bolt
- 1x M10 90mm
- 4x M10 nuts
Assembly instructions:
(Notice! You may need to use a 5/16" drill bit to expand the arrow slots. If too loose, use silicon
Improvements include:
- Better print-ability without supports.
- Smaller dimensions (less plastic = faster print)
- Improved slots for bolts
I wanted to create a simple bow stabilizer that is not only great looking, but also is functional. This version of the stabilizer will save you a lot of print time, and material. By using 4 used/old/found arrow shafts, and going to the store to buy a couple of parts, this project will cost you only about $5.
3D Parts needed:
- 1x Receiver (1.25" OR 2")
- Rail (Need 1. Print as many as you would like)
- 1x Barrel
- 1x Flash Hider OR Silencer (Optional, but it adds on to the looks of it.)
Parts required to assemble:
- 4x 7.8mm Arrow shafts
- 1x UNF 5/16*24 1.25" OR 5/16-24 2" bolt
- 1x M10 90mm
- 4x M10 nuts
Assembly instructions:
(Notice! You may need to use a 5/16" drill bit to expand the arrow slots. If too loose, use silicon
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
