Extreme Bow Stabilizer - VERSION 2 AVAILABLE NOW - Customizable!

VERSION 2 IS AVAILABLE HERE: https://www.thingiverse.com/thing:2463721

This bow stabilizer was inspired by this one: https://www.thingiverse.com/thing:1152975

I wanted to create a simpler version of the bow stabilizer, that still retains it looks, and functionality. This version of the stabilizer will save you a lot of print time, and material. By using 4 used/old/found arrow shafts, this project will cost you only about $5.

3D Parts needed:
- 1x Receiver (1.25" OR 2")
- Rail (Need 1. Print as many as you would like)
- 1x Barrel
- 1x Flashhider OR Silencer (Optional, but it adds on to the looks of it.)

Parts required to assemble:
- 4x 7.8mm Arrow shafts
- 1x UNF 5/16*24 1.25" OR 5/16-24 2" bolt
- 1x M8 washer
- 1x M8 nut
- 1x M10 90mm
- 4x M10 nuts

Assembly instructions:
(Notice! You may need to use a 5/16" drill bit to expand the arrow slots. If too loose, use silicone glue or hot glue to secure everything in place.)
1. Receiver: If you printed the 1.25" or