Thingiverse
Extreme bridge test
von slimc
63
Downloads
36
Likes
1
Makes
This test lets you see the maximum usable bridge for your 3D printer.
The model tests bridges from 5mm to 90mm with 5mm gaps.
The model is made to use 0.2 mm layerheight, but 0.1 can be used if you want. 0.3 is not recommended.
The model tests bridges from 5mm to 90mm with 5mm gaps.
The model is made to use 0.2 mm layerheight, but 0.1 can be used if you want. 0.3 is not recommended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!