Extruded Frame Spool Holder

Here is my Spool holder for my Tevo Tarantula. Printed in eSun PLA+ Cold White

You will need:
1 Bearing 8X22X7
4 T-Nuts
4 M4 10mm bolts

You will need to print at least 2 LockingNut.stl, but i printed 3, the third locks the SpoolBolt.stl in place.

The threads turn well, but it they're too stiff some WD40 or Bike Grease will help them turn easier. It is a good idea to print the LockingNut.stl and SpoolBolt.stl at 102% though, just to give the thread that extra tiny bit of room.

Depending on your printer layout you may need to mirror FrameMount.stl to avoid having the filament hang over the print bed.

The idea for the opposing cones to hold the filament came from the filastruder.

The bearing that goes into the SpoolBolt.stl may need some super glue depending on your machines accuracy. I had to sand mine down and press fit so your mileage may vary.

Last point, the HolderBolt.stl carries a lot of weight on it's tip, so the more solid you can make that end the bette