Thingiverse
Extruder Calibration Helper
von Supertas80
8
Downloads
3
Likes
0
Makes
With this tool you can easier make an extruder calibration.
1. messure 12cm from right (upper Scala)
2. Extrude 10 cm
3. Read the value at the deeper scala
Made for 1.75 Filament
Not easy to print so fine. This is the reason for two versions
1. messure 12cm from right (upper Scala)
2. Extrude 10 cm
3. Read the value at the deeper scala
Made for 1.75 Filament
Not easy to print so fine. This is the reason for two versions
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!