Thingiverse
Extruder + Filament sensor
von denicola
3
Downloads
1
Likes
0
Makes
Modified **original ender 3** extruder
**ARM** M5 coupler. (optional)
Works with **original ender 3** endstops.
**BASE** M6 coupler.
Add PTFE tube to base.
Lid screw **not** needed lid is snap-fit. (M3)
***Not tested on a bowden system might get in the way with the leadscrew***
**This is a remix from 2 models**
*Filament sensor* https://www.thingiverse.com/thing:4629979
*Extruder Arm* https://www.thingiverse.com/thing:3059247
**ARM** M5 coupler. (optional)
Works with **original ender 3** endstops.
**BASE** M6 coupler.
Add PTFE tube to base.
Lid screw **not** needed lid is snap-fit. (M3)
***Not tested on a bowden system might get in the way with the leadscrew***
**This is a remix from 2 models**
*Filament sensor* https://www.thingiverse.com/thing:4629979
*Extruder Arm* https://www.thingiverse.com/thing:3059247
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
