Thingiverse
Extruder Finger Grip
von RiggedCreations
3
Downloads
4
Likes
0
Makes
Finger grip for aftermarket (red) extruder for Ender 3 Pro.
Will probably fit the stock extruder also.
Grip makes it easier to hold the extruder open when loading or unloading filament.
Grip should clear cables/cable chains running behind the extruder.
Used the screw that came with the stock extruder.
Clearance over screw that holds the extruder plate to the stepper motor is tight. You may have to mount it at a slight angle or you can sand it to fit.
Will probably fit the stock extruder also.
Grip makes it easier to hold the extruder open when loading or unloading filament.
Grip should clear cables/cable chains running behind the extruder.
Used the screw that came with the stock extruder.
Clearance over screw that holds the extruder plate to the stepper motor is tight. You may have to mount it at a slight angle or you can sand it to fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!