Extruder Relocation
von evilhellfire
6
Downloads
4
Likes
0
Makes
Hi,
bought a new extruder and was tired of always working so close to the rod so i designed this.
I know there are many designs out there but i am still learning Fusion so this was a good practice.
Gave it 15 % infill 3D honeycomb with prusaslicer
On the "handle" (you can see this in a picture) i filide down some material and placed a copper busching underneath... smoother rolling of the gear
I hope you like it and if you print it ... please post a picture
bought a new extruder and was tired of always working so close to the rod so i designed this.
I know there are many designs out there but i am still learning Fusion so this was a good practice.
Gave it 15 % infill 3D honeycomb with prusaslicer
On the "handle" (you can see this in a picture) i filide down some material and placed a copper busching underneath... smoother rolling of the gear
I hope you like it and if you print it ... please post a picture
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
