Thingiverse
Extruder Swinger
von Dustys_Corner
7
Downloads
4
Likes
0
Makes
Pleased to share this design. Took me a lot of tinkering. Being inside an enclosure, trying to change filament is a hassle - No longer haha! Swings easily 180 degrees. A huge stress relief!
* Tried to save material/time by making the backing plate thinner.
* Added markings for the sake of it.
* Added support to increase strength without adding much weight.
* Added a vent port to remove any excess heat generated from the extruder gear.
* Made top holes elongated to allow a little wiggle room. You can move motor without having to dismantle the extruder and relocate the bracket and then reassemble. [YAY!]
* Makes changing filament a breeze!!!
* Ignore the attached arm, that's another project but you can see things can be added to the Swinger like a filament guide.
- You'll need M4 nuts/bolts to mount to frame
- You'll need 1xM4 10mm bolt and nut (Nylon lock nut if possible) to assemble The ExtruderSwinger pieces together. The nut might have to be pressed in.
- M3 bolts for
* Tried to save material/time by making the backing plate thinner.
* Added markings for the sake of it.
* Added support to increase strength without adding much weight.
* Added a vent port to remove any excess heat generated from the extruder gear.
* Made top holes elongated to allow a little wiggle room. You can move motor without having to dismantle the extruder and relocate the bracket and then reassemble. [YAY!]
* Makes changing filament a breeze!!!
* Ignore the attached arm, that's another project but you can see things can be added to the Swinger like a filament guide.
- You'll need M4 nuts/bolts to mount to frame
- You'll need 1xM4 10mm bolt and nut (Nylon lock nut if possible) to assemble The ExtruderSwinger pieces together. The nut might have to be pressed in.
- M3 bolts for
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
