ExtrudeReel

Edit - 1/10/2018 - I had to flip the filament feeding port below the extruder mounts as both of mine, the filament is cutting up into the apex and is eventually going to pinch my filament and cause drag on my extruder steppers. Also, I added a cylinder to round off the edge that the filament contacts to improve feeding while combating the saw-like forces, but also give the filament room to slide back and forth so as not to always glide over any one spot.

Edit - 12/16/2017 - I added base mounting holes and decreased the radii under the bridge to lessen the overhang and decrease the chance for curling.

This is an idea I've been tossing around for months, a spool holder that also holds the bowden extruder. I already have a remix in mind too as I'm not entirely content with the current height of the extruder and I'd like to raise it up another 100 or so mm.

I printed at 65mm/s with no support. I have custom supports inside the mount tracks which make for very little waste. Th