Thingiverse
Extrusion top spool holder
von nathanstenzel
0
Downloads
0
Likes
0
Makes
This is a filament spool holder to go on the tops of 20mm extrusion.
Based on Thingiverse thing #4212228 which doubles as a handle.
Unfortunately, most printers are too heavy to pick up the printer by this spool holder that goes on 20mm extrusion. Seriously, I do not recommend it. Grab the printer by the top rail.
I repeat.
NOT A HANDLE
I recommend putting the smoothest side of the thin piece up. That will allow the spool to move more freely.
Based on Thingiverse thing #4212228 which doubles as a handle.
Unfortunately, most printers are too heavy to pick up the printer by this spool holder that goes on 20mm extrusion. Seriously, I do not recommend it. Grab the printer by the top rail.
I repeat.
NOT A HANDLE
I recommend putting the smoothest side of the thin piece up. That will allow the spool to move more freely.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
