Thingiverse
Extrusion Tripod
by magdel16
4
Downloads
3
Likes
0
Makes
A tripod mount that can be attached to 20mm x 20mm extrusions.
The leg is 260mm (10.23 inches) because that was the most I could fit on my print bed diagonally. Should you want to make custom legs, the current one is 20mm wide and 15mm high. The hole is 6mm in diameter.
The leg is 260mm (10.23 inches) because that was the most I could fit on my print bed diagonally. Should you want to make custom legs, the current one is 20mm wide and 15mm high. The hole is 6mm in diameter.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
