Slicer Discord
Eyeball Container – Modèle 3D imprimable de MakerWorld MakerWorld
Decor

Eyeball Container

par blecheimer · Decor
540 Téléchargements
215 Likes
343 Makes
Voir le modèle
"Here's looking at you, kid." Ok, in general you only have two eyes. This might be sufficiant, but why not have some spares? Print your own eyes in your favourite colour.And there is more - these eyes not only look good, but you can open them. Only a few rotations and you can place some candy inside as a spooky giveaway. Printing is quite easy: Print everything with three walls, four tops & bottoms and 8% gyroid infill. Support is not needed. For a neat tumbling figure effect you can make the bottom half extra heavy by printing it with 20 tops & bottoms. Then the pupil will always face up. After printing glue the iris and the pupil to the top half. Screw the thread in one of the halves and close the container by screwing the other half to it. For an optional reflex effect draw a single white dot on the iris. Just use white paint or a white permanent marker. Disclaimer:This work by blecheimer is licensed under a Standard Digital File License. It is for personal use only (e.g
Catégorie
Decor
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Pourquoi ?
post-traitement important
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 3/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Post-traitement
Peinture, Collage, Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Même créateur, plus de plateformes

blecheimer publie également sur

264 modèles supplémentaires sur 3 autres plateformes

Vérifié par correspondance des titres de modèles entre plateformes.
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection