Thingiverse
EZ-Up Corner Slider
door ajh339
10
Downloads
5
Likes
0
Makes
Replacement corner slider for EZ-UP 10x20 tent. Couldn't buy a replacement. It's a bit rough, but functional, feel free to improve. Would probably be better to use a stronger material than PLA, but is working so far.
Will need to drill holes for the two little screws that hold the set pin in place, and may need to widen some of the holes depending on your bolts.
Will need to drill holes for the two little screws that hold the set pin in place, and may need to widen some of the holes depending on your bolts.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
