EZ-Wifibroadcast MicroQuad Testing Platform

In my ongoing quest for affordable micro HD FPV, this quick prototype clean/dirty separated frame was created as a slightly more crash-proof smallest possible platform to mount a pi zero, WN722N wifi usb TX, naze32, and babyhawk/FT gremlin power train. This frame design is a super-rough prototype as I'm still chasing down vibrations that don't appear with analog FPV. Could just be the FC tuning.

There is no space for an R/C receiver since this requires none as the control signal transmits from a USB gamepad (or Taranis in USB mode) over the wifibroadcast link. You also do not need a separate OSD as the pi zero transmits the FC's telemetry down the link as well. To use this frame as intended, you will have to strip out all unnecessary weight/components off the wifi card and direct solder the usb/power connections, etc, including the antenna.

On my current flying prototype (not pictured), the lower frame/arms is actually 1.5mm fiberglass G10 for toughness but it is flyable if