EZStruder MK8 Mod

This is a mod for the SeeMeCNC ezstruder, allowing it to use a MK8 hobbed gear and bowden passthrough connector. You'll need an ezstruder, as it uses the bearing arm that comes with it. Technically you could source the bearing and spring yourself, but it helps to start with the original. You'll also need an E3D (or Prometheus) passthrough connector for the bowden tube, and a MK8 hobbed gear.
The end result is the MK8 provides ~34% more torque than the original MK7 gear, and the passthrough means that the bowden tube runs right up to the gear, helping keep the filament snag free.

*EDIT* After lots of testing, here are the existing issues: The faceplate which helps keep the red arm aligned can loosen over time, I need to embed a nut for to hold the screw instead of just threading into plastic. Also, the spring pressure is a liiittle strong, with one spool of ABS the filament would sometimes get flattened.