Thingiverse
F-16 model
di H_Alvi
9
Download
5
Likes
0
Makes
Hey every one!
This is my design modeled after the F-16. It was originally intended to be a an RC model cut out of foam board, but I figured since I had the 3D files, I would scale it down and post it hear as a 3D printable model.
Here are some print settings I would like to suggest while printing:
Infill Density: 5% to 10%
Parameters: 3
Temperature: 200C (however it depends on the Type of material you are using)
Layer Height: 0.16 - 0.2 mm
Nozzle: 0.4mm
Note:
Print all the parts individually and assemble the model using glue (hot glue, CA, etc...)
I hope you guys enjoy creating this model.
This is my design modeled after the F-16. It was originally intended to be a an RC model cut out of foam board, but I figured since I had the 3D files, I would scale it down and post it hear as a 3D printable model.
Here are some print settings I would like to suggest while printing:
Infill Density: 5% to 10%
Parameters: 3
Temperature: 200C (however it depends on the Type of material you are using)
Layer Height: 0.16 - 0.2 mm
Nozzle: 0.4mm
Note:
Print all the parts individually and assemble the model using glue (hot glue, CA, etc...)
I hope you guys enjoy creating this model.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
