Thingiverse
F-16 Throttle – PC Simulator
door Alexey4X
222
Downloads
221
Likes
7
Makes
F-16 throttle for PC simulator.
I printed it with Creality Ender 3 v2.
See the attached Docx file with all project data and the fasteners list.
It was assembled with an Arduino Leonardo board.
Code from here:
https://github.com/ValkA/f-16-throttle-joystick
(Thanks to ValkA)
Some remix parts are taken from here:
https://www.thingiverse.com/thing:4733645
https://github.com/JonahTsai/F16/tree/master/Throttle
(Thanks to Jflyer81)
(Thanks to JonahTsai)
VIDEO: https://www.youtube.com/shorts/u4Ut2HWRl0w
Afterburner Tooth part with 624Z bearing (4x13x5mm) and M4 screw.
https://youtu.be/GRi3MBTdHAE?si=a7aYP4QvZG7tuP6r
VIDEO on how to adjust controls setup in DCS: https://youtu.be/04r7eTb0fZ4
I printed it with Creality Ender 3 v2.
See the attached Docx file with all project data and the fasteners list.
It was assembled with an Arduino Leonardo board.
Code from here:
https://github.com/ValkA/f-16-throttle-joystick
(Thanks to ValkA)
Some remix parts are taken from here:
https://www.thingiverse.com/thing:4733645
https://github.com/JonahTsai/F16/tree/master/Throttle
(Thanks to Jflyer81)
(Thanks to JonahTsai)
VIDEO: https://www.youtube.com/shorts/u4Ut2HWRl0w
Afterburner Tooth part with 624Z bearing (4x13x5mm) and M4 screw.
https://youtu.be/GRi3MBTdHAE?si=a7aYP4QvZG7tuP6r
VIDEO on how to adjust controls setup in DCS: https://youtu.be/04r7eTb0fZ4
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!