F-One Foil Shim

Modeled these shims to work with the latest F-one foil system to be able to shim the rear foil.

The files should result in the following shim angles

-1.25 deg
-1.00 deg
-0.75 deg
-0.50 deg
+0.50 deg
+0.75 deg
+1.00 deg
+1.25 deg

I only got to do one test fit on one fuse/foil. checked against the F-one eagle.
https://www.f-one.world/wing-surf/hydrofoils/

These are designed to be printed flat, and should be soft enough to just install. for the thicker ones, you might want to heat them up a little bit right before installing.

Can be printed in any rigid filament, I have printed in PETG and PLA, but would likely recommend ABS. they are only loaded under compression so it doesnt really matter! I printed these solid with no infill be increasing the top and bottom layer count to cover the full build.

keen on any feedback!