Thingiverse
F1 Front Wing Keychain
by JoshuaLotion
11
Downloads
42
Likes
0
Makes
Made a remix to turn this nice design into a keychain.
I printed at 0.2mm layer height. Its important to get good support height so it doesnt stick to the model too much. Might break off the wing when removing since its only 1 layer thick
I printed at 0.2mm layer height. Its important to get good support height so it doesnt stick to the model too much. Might break off the wing when removing since its only 1 layer thick
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
