F1 Logo (1994-2017)

I wasn't able to find any F1 logo from this era that I liked, so I put my own together in TinkerCAD, using a copy of the official logo, so the dimensions are accurate.

I borrowed the base from another great F1 logo on Printables: https://www.printables.com/model/152208-decorative-f1-logo-formula-1

I've also included an optional white backing, which can be used if the logo is placed in front of a dark wall or object. This helps to highlight the number "1" in the middle of the logo. I just stuck it on with blutac, so it can come off if needed.

I used a 0.2mm nozzle for the red part, to get the best definition on the "spikes". But I suspect a 0.4mm nozzle would work ok too. 0.4mm nozzle is fine for the other parts.

The fitment of both parts into the base are quite tight, so no glueing is needed. The red part may be slightly too tight. I found I just had to sand/scrape a small amount from the bottom. You could also just reduce the size by a percent or two.