Thingiverse
Fabrikator mini v2 spool holder – optimized
door SuperNES
45
Downloads
26
Likes
2
Makes
I tried Glennbeekhof's spool holder, but it did not fit on my Fabrikator, so I redesigned it.
- bigger slot to fit on the machine without force
- connection bar in the middle of the slot
- the rod is now a little deeper (3 mm) in relation to the connection part
- the rod is shorter (65 mm, better center of gravity)
- visually appealing, smaller cover plate
It fits perfect for my Das Filament 800 g spools (outer diameter 200 mm, inner diameter 52 mm, spool width 55 mm).
Made with FreeCAD.
- bigger slot to fit on the machine without force
- connection bar in the middle of the slot
- the rod is now a little deeper (3 mm) in relation to the connection part
- the rod is shorter (65 mm, better center of gravity)
- visually appealing, smaller cover plate
It fits perfect for my Das Filament 800 g spools (outer diameter 200 mm, inner diameter 52 mm, spool width 55 mm).
Made with FreeCAD.
SuperNES publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
