Thingiverse
Fabscan - Pi camera mount for Cube-Case
von willie42
15
Downloads
11
Likes
1
Makes
The new software version of the fabscan - the fabscan pi - uses a raspberry-pi 2 and a pi-cam.
To mount the cam in the approved manner instead of the c270, I drew a little board as an adapter - just like the original one shown here:
http://www.thingiverse.com/thing:476507
You need two or three very little screws to fix the cam.
You will have to adjust the coordinates in /etc/fabscan/default-config.json
Here is, how to measure them::
https://github.com/mariolukas/FabScanPi-Server/blob/master/doc/SOFTWARE.md
UPDATE:
Added a version with a mount for a LED-ring. The ring I use has a diameter of 50 mm and four holes in a distance of 33 mm each.
To mount the cam in the approved manner instead of the c270, I drew a little board as an adapter - just like the original one shown here:
http://www.thingiverse.com/thing:476507
You need two or three very little screws to fix the cam.
You will have to adjust the coordinates in /etc/fabscan/default-config.json
Here is, how to measure them::
https://github.com/mariolukas/FabScanPi-Server/blob/master/doc/SOFTWARE.md
UPDATE:
Added a version with a mount for a LED-ring. The ring I use has a diameter of 50 mm and four holes in a distance of 33 mm each.
willie42 veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!