Thingiverse
Face Mask Remix
por Lord_bizness
2
Descargas
0
Likes
0
Makes
The original designs look great, but they are to big for the voxel (150x150x150). This remix splits the design into thirds and arranges them to just (just!) barely fit on my voxel.
The "Front" of the mask is 5mm and the "back" of the mask is 2mm. This way, when completed, the back / front pieces can be glued together using the size difference to build up the adhesive.
On the "front" of the mask, these is a groove where an additional bead of adhesive can be used for more stability.
I am planning on using JB Weld as I had great success doing that on the open rc car.
The "Front" of the mask is 5mm and the "back" of the mask is 2mm. This way, when completed, the back / front pieces can be glued together using the size difference to build up the adhesive.
On the "front" of the mask, these is a groove where an additional bead of adhesive can be used for more stability.
I am planning on using JB Weld as I had great success doing that on the open rc car.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
