Thingiverse
Face protection shield
door brittenIslander
1
Downloads
0
Likes
0
Makes
Due to Covid-19 crisis, I was looking to build a facial shield protection with a transparency film.
Unfortunately, I didn't find a model fitting my Up Mini. So I decided to make it myself and share the design.
The thing can be built easily !
1. print the support
2. use a transparency film in landscape position and make three holes, on the top center, separated each others by 5.5 cm, using a paper punch.
3. at the top extremity of the transparency film make two more holes with a paper punch on each sides,
4. finally, fix the transparency film on the printed support and attach a rubber between the two hooks, passing through the two external holes of the transparency film (see picture).
Printed and built in less than 40 minutes !
Unfortunately, I didn't find a model fitting my Up Mini. So I decided to make it myself and share the design.
The thing can be built easily !
1. print the support
2. use a transparency film in landscape position and make three holes, on the top center, separated each others by 5.5 cm, using a paper punch.
3. at the top extremity of the transparency film make two more holes with a paper punch on each sides,
4. finally, fix the transparency film on the printed support and attach a rubber between the two hooks, passing through the two external holes of the transparency film (see picture).
Printed and built in less than 40 minutes !
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!