Slicer Discord
Face Soap Stamp – 3D-Druckmodell von Thingiverse Thingiverse

Face Soap Stamp

von emikanj2
18 Downloads
19 Likes
0 Makes
Zum Modell
Got tired of TSA pulling my smooth and non-descript bars of facial soap out of my bags and asking me what it was and testing for gunpowder residue. The whole point of using a bar of soap was that I didn't have the hassle of traveling with liquids.

Here is a stamp that will clearly label a square bar of soap with the words "Face Soap". The stamp is meant for a bar about 8 by 8 cm, but could also work for most LUSH square bars. If you get the imprint deep enough (2-3mm) it can be read as the soap goes through an X-ray scanner, though be warned too much pressure may break the soap into pieces, especially if it is a brittle bar.

I would recommend at least 30% infill, though you could get away with less, it just makes the stamp and words less durable.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Schleifen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen