Faceplate for AMS Lid Riser v2

This faceplate is meant to be used with DesignCraft's AMS Lid Riser for Bambu Lab AMS v2. I love the lid riser, but didn't like the seam in the middle of it. I realized there was just enough space on the build plate to print a faceplate for it to cover up the seam. By just enough I mean I use almost every diagonal mm of the plate, as the model is 358mm long. Dimensions:23.60mm H x 358mm L X 3mm W (The ribs add another .78mm to the width) Printing:The ribs are at an angle that don't require support. This print requires a clean build plate to not warp or some glue. I've printed this in testing the design about 5 or 6 times in PLA and never had any warping issues, but I cleaned my build plate in-between each printing. I'd also say this print requires you to make sure your physical build plate is completely properly centered too, as it's going to use 99% of the available diagonal build area. Assembly:Put a little glue (a little glue goes a long way) on the ribs and