Thingiverse
Factorio Splitter
von warmarine759
48
Downloads
51
Likes
3
Makes
The Factorio splitter with rotating gears. I used a M3 bolt as a rod gluing the end to the base the holes should be slightly over 3mm wide.
for the sliding bar i used 1.5mm steel rods but theres also a printed stationary piece
for the sliding bar i used 1.5mm steel rods but theres also a printed stationary piece
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
