Factory gate - draft 001 &002

I changed to #inprogress because I add(ed) more stuff and variants.

I had to design a factory gate for a H0e layout matching my TT (1/120) scale printed walls. So this design is in 1/120 scale.

First try was 52mm wide, 32mm high. Second variant of draft 001 -- because of my mistake -- is 57mm wide. To allow the position of the columns a little deeper / street or track higher, the draft 002 has o.8mm space to the zero level of the column.

I printed it on an Anycubic Mono 4 Ultra. I drilled the 0.45mm holes with 0.5mm and added a 0.4mm brass wire to keep the parts connected.

**Versions**

Result|Files
52mm wide|draft001 side01 and 02
57mm wide|draft001 side01_57mm and side02_57mm
57mm wide and 0.8mm above the floor|draft002


.
All hinges and the column fit draft 001 and 002 files. You have to mirror the column in slicer, it's asymmetric. The column was taken from my design: https://www.thingiverse.com/thing:7164527

If you use only the single hinges, it will fit a vertical wall.