Thingiverse
Falcon Coaster
von Taeho98
48
Downloads
36
Likes
0
Makes
This is my SpaceX Falcon 9 inspired coaster. The coaster is made to resemble the grid fins with the chevrons at the back!
- The walls are thin so I recommend a linewidth of 0.4 or less
- The print is separated into 2 parts for a 2 tone effect - part "A" is the outside rim and "B" the hub. The 2 parts also allow for a little lip at the top without the need for support
- Make sure to print part B with the chevrons facing up so that no support is required
- A few drops of glue can be used to attach the parts together
- The walls are thin so I recommend a linewidth of 0.4 or less
- The print is separated into 2 parts for a 2 tone effect - part "A" is the outside rim and "B" the hub. The 2 parts also allow for a little lip at the top without the need for support
- Make sure to print part B with the chevrons facing up so that no support is required
- A few drops of glue can be used to attach the parts together
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
