Thingiverse
Faller car system Hallsensor/Sensor Mount
por Zemizz
13
Descargas
6
Likes
0
Makes
It's designed for easier installment (and replacement) of hallsensors for the faller car system or any other car system.
The cap is permanently glued in a 8,5mm hole in a gap between two ends of the magnet band or car system wire. For the best results make sure to install the cap flush into the road surface.
The sensor, with wires attached to it, is glued on top of the screw (the wires can be run through the hole).
The cap is permanently glued in a 8,5mm hole in a gap between two ends of the magnet band or car system wire. For the best results make sure to install the cap flush into the road surface.
The sensor, with wires attached to it, is glued on top of the screw (the wires can be run through the hole).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!