Fallout Laser Rifle Scope

This is a model of the scope for the laser rifle from Fallout 4. I've made it compatible with the laser rifle by Faran3D which uses magnets to attach the optics. I stuck close to the original model from the game though I had to change the wire routing slightly. I printed it in PLA. Assembly is pretty simple and glue is required for assembly. There are a few spots where you could run into trouble though. First, you need to put the straight yellow tube (wire) between the two clips before attaching that assembly to the left side. One small piece, where the wire terminates, fits into a corner on the underside of the bracket. See the third picture indicating where it needs to be glued. Finally, the knob on the rear needs to be installed before attaching the rear lens piece. Other than that, most pieces seat into holes or use the small pegs to aid alignment. Be sure to remove the support material that can fill the small holes. Holes on the bottom fit three 6 x 3 mm magnets for attachment