Thingiverse
Fallout Vault Tec Fidget Slider
par Empty_Dustpan
14
Téléchargements
35
Likes
0
Makes
The Vault-Tec logo from Fallout - in fidget slider form!
- SUPERGLUE IS REQUIRED FOR THIS MODEL -
Materials needed:
12 * 8x3mm neodymium magnets
I used these 8x3mm magnets from amazon which are actually 8x2.75mm: https://a.co/d/hJVzD7e
Instructions:
- Add a small drop of superglue at the bottom of each hole.
- Carefully insert a magnet into each hole and press it all the way in (Keep the magnets' polarity in mind for each half!)
- Add a thin layer of superglue to the bottom of the cover and firmly press it into the fidget slider.
- Repeat for the other half of the slider.
- Enjoy!
Please consider supporting my models over on MakerWorld: https://makerworld.com/en/@Empty_Dustpan
- SUPERGLUE IS REQUIRED FOR THIS MODEL -
Materials needed:
12 * 8x3mm neodymium magnets
I used these 8x3mm magnets from amazon which are actually 8x2.75mm: https://a.co/d/hJVzD7e
Instructions:
- Add a small drop of superglue at the bottom of each hole.
- Carefully insert a magnet into each hole and press it all the way in (Keep the magnets' polarity in mind for each half!)
- Add a thin layer of superglue to the bottom of the cover and firmly press it into the fidget slider.
- Repeat for the other half of the slider.
- Enjoy!
Please consider supporting my models over on MakerWorld: https://makerworld.com/en/@Empty_Dustpan
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !