MakerWorld
Garden
Zum Modell
Fallrohr Watercollector
13
Downloads
14
Likes
0
Makes
Rainwater collector to be integrated into the downpipe. standard EU drain pipe size = DN100 = 10cm. The ring allows to take between 9 and 10cm pipe. Upper pipe is sitting on a ledge, the hood in the middle is printable without support,only support (manually added) was to the outlet pipe. I also added a small brim, both because I do not trust my ASA prints (they have detachment issues) – this printed without any trouble, brim and supports came off very easily. (printed in ASA because it needs to be UV-resistant)Model might be simply up/downsized if your pipe has a different diameter.Solid piece, does a perfect job.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!