Thingiverse
False Knight Miniature
door PretzelANGRY
39
Downloads
41
Likes
0
Makes
Printed Miniature of Hegemol/False Knight from Hollow Knight. Prints roughly 4 inches tall with plenty of bulk. Roughly 1:1 scale (probably).
Sliced parts are for easier supports on FDM printers and can be assembled with superglue. I haven't experimented with printing the full figure in one go, but have included the files regardless.
Recommend very low infill ~5% or you will be wasting lots of filament. Prints in decent time at 0.15 layer height.
Figure may snap off base easily, if this becomes too much of a problem you can either bury the feet in plenty of 2 part epoxy, or drive in an unfolded paperclip with a soldering iron and pliers as a kickstand.
Sliced parts are for easier supports on FDM printers and can be assembled with superglue. I haven't experimented with printing the full figure in one go, but have included the files regardless.
Recommend very low infill ~5% or you will be wasting lots of filament. Prints in decent time at 0.15 layer height.
Figure may snap off base easily, if this becomes too much of a problem you can either bury the feet in plenty of 2 part epoxy, or drive in an unfolded paperclip with a soldering iron and pliers as a kickstand.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
