Fan and sensor mount

replace stock mount for fan and sensor
(mounts in same exact spot, longer screws needed, extras were provided in the assembly) adds cooling fan and ducting
i used Cura in Repetier didn't change any setting.
position mount for a vertical build.
The ducting can be printed with out support material,
(the position in the provided pic is not the correct position, it should be standing almost upright)
Position it the correct way before slicing
( a little superglue to your ducting and fan to secure it).
Use 3mm screws on all. For the fan i added a nut as a spacer, do not over tighten, it only needs to be "kinda tight"