Thingiverse

Fan Filtering Unit

by BKoekel

116 Downloads

41 Likes

0 Makes

This is a fan filtering unit for use on any printer enclosure.
It's designed to use in combination with the Nilfisk AirCare HEPA filter and a 92x92mm fan.
I added it to the
Prusa Printer Enclosure V2..

Size: 145*134mm, about 60mm deep when using a 25mm fan.

You will need:
4x M4x35mm screw
4x M4x20mm screw (for mount on a 3mm Acrylic sheet, adjust to your needs.)
8x M4 nut
1x 92x92mm fan. (I used a 230VAC unit running on the mains of the printer in combination with a temperature controller and a SSR)
1x Nilfisk HEPA filter (GM 200 - 499 series)
1x Universal carbon filter for kitchen hood, cuttable. (optional)

You can use the FFU_Grid_DrillAssist part to mark the cut out on the desired location.
After marking your filter cut out and drill holes remove the 4 corners from the model using a snap-off knife.

92mm 92mm fan 92mm Fan mount carbon carbon filter fan Fan mount FFU filter hepa HEPA filter 92mm 92mm fan 92mm Fan mount carbon carbon filter fan Fan mount FFU filter hepa HEPA filter

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format