Thingiverse
Fan replacement 80 mm
por DaniiPere
15
Descargas
17
Likes
1
Makes
Repair to replace the blades of an 80mm fan (Size equal to that of a standart fan of electronic housing, larger than normal 40mm)
There is three versions. Select V3!
Be sure to place the right side of the blades up in the laminator, because I intuit that you want to leave the side that sticks to the bed, out of the engine (The first layer is usually flat and it suits you to stay out) And you want Let the wind blow in your favor!
You must be careful so that when the blades are moving they will not collide with anything or they will break.
There is three versions. Select V3!
Be sure to place the right side of the blades up in the laminator, because I intuit that you want to leave the side that sticks to the bed, out of the engine (The first layer is usually flat and it suits you to stay out) And you want Let the wind blow in your favor!
You must be careful so that when the blades are moving they will not collide with anything or they will break.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
