Fancygotchi Case: Raspberry Pi + PiSugar2 USB-C

This is a 3D-printable case designed specifically for the Fancygotchi project, compatible with the Raspberry Pi and the PiSugar2 1200mAh (USB-C version). ⚠️ It’s a snug fit and will require a bit of careful assembly. 🔧 Assembly Instructions: Step 1: Start with the screen: Remove it from the RPi and screw it into the front faceplate using M2x8 hex screws, washers, and bolts. Step 2: Insert the buttons: Drop the buttons into the button wells in the case. Step 3: Slide in the Pi: Carefully insert the Raspberry Pi with the PiSugar2 attached. Make sure to remove the SD card first to avoid damaging it. Step 4: Add the top cover: Snap or press it into place once everything is aligned. Step 5: Final assembly: Attach the front faceplate (with screen) to the Raspberry Pi. You may need to adjust the hex screws slightly to get everything flush and secure, then insert the SD card. And that’s it! your Fancygotchi is rea